README        this file
EPROMS.ZIP    the binary files needed to burn your own eproms
MAN_WP60.ZIP  the manual in WordPerfect 6.0 format

---------------------------------------------------------------------

                           RLC-4 Update V1.24

A lot of things have changed since V1.13 (the original and only
other release before now), but most of them are internal and
don't change how you use the controller.  When you replace the
prom, make sure you get the notch on the right end (don't go by
the label).  Replacement manual pages are included for the
commands that have changed or been added (and for a few other
commands to make the pages fit right).  It should be fairly
straightforward to replace the pages in your current manual with
the new ones.  The right and left sides should match up.  You
will have to go by the command names when finding where the pages
go because there are places where there are more new pages than
old ones and that messed up the page numbers.  We will try to fix
that and get you an updated table of contents in the future.  The
original page numbers that will be replaced follow (only the
front page of each is listed):  29, 31, 33, 43, 55, 67, 71, 75,
77, 79, 89, 117, 119, 121, 123 (number is missing - it says 124
on the back), 131, 133, 159, 161.

There are too many little changes to bother telling you about all
of them, but a few of them are worthy of note:
* The time out timers now time the receivers rather than the
transmitters.
* A couple of problems that could make a link transmitter drop
  when it was not supposed to have been corrected.
* The commands to insert and delete commands from a macro used
  to mess up the courtesy beep for port 2.
* All of the macros were treated as being 50 characters long
  even though 200..249 are only 20 characters long.  This caused
  problems when macros numbered above 200 were filled to more
  than 40% of capacity.

If you find any problems with this release or have any requests
that you have not told us about for future releases, please let
us know in writing by one of the following methods:
* Mail to:  

Link Communications, Inc.
1035 Cerise Rd
Billings, MT 59101-7378

Email: info@link-comm.com
WWW homepage: http://www.link-comm.com

Orders Only: 		(800) 610-4085
Technical Support: 	(406) 245-5002
Fax: 			(406) 245-4889

We are working toward supporting more remote bases.  Because of
memory limitations, we plan to offer a different version of the
software for each general radio type.  You will not receive this
update unless you return your old EPROM or pay us for it ($10). 
When you return your EPROM, please let us know which of the
following options you would like with the next release:
* Doug Hall RBI-1 support for Kenwood mobile radios (what you
have now)
* Kenwood serial controlled radio support
* Icom serial controlled radio support
* Yaesu serial controlled radio support
* Possibly:  software based scheduler (would not keep track of
time if the power failed)
* Requests????