Manual Update for V1.65

The RLC-3 manual has not been updated since V1.53.  This document 
is the only record of changes.  The manual will be updated when 
time permits. 

Added the password commands (186...)  They were not in software 
version 1.53, but they are in the V1.53 manual. 

Added command 'N' to all controllers to allow uploading without 
worrying about command names.  In previous versions, if you 
changed the name of a command and later tried to upload a file 
that called that command, it would not be able to find that 
command name and would cause an error.  Now when sending commands 
from the serial port, you can now put an 'N' followed by the 
command number and any data for that command and not have to 
worry about what the command has been renamed to.  For example, 
to program a courtesy beep: 

  V1.48 and previous:  "C053*2680400500500500*    ; send beep"
  V1.53: "053 268 040 050 050 0500 ;                send beep"
  V1.65: "N053 268 040 050 050 0500 ;               send beep"

Changed command 138 (send spi out card) to hex, not decimal. 
Should make it easier to control BCD radios.  The only thing I 
know of it being used for now is recalling memories on the RBI-1, 
which will still be possible with this command and is now a 
standard command anyway. 

Changed autopatch hangup voice/cw response so is only sent if not 
already hung up.  

Added a command 157 event that is called if try to hang up the 
patch when it is already hung up.  It is event number 208. 

Made the keypad test use the words "star" and "pound" rather than 
"s" and "p". 

Now allow variable length when selecting what timer to recall, 
reset or clear. 

Added Doug Hall RBI-1 automatic band switching.  Also allow 
memory recalling, and made the recall frequency and recall all 
commands aware of the memories.  Added a command to turn the 
radios on and off. 
- Command 141 is no longer needed, since the band is switched 
  automatically by command 142. 
- Command 142 now takes the whole frequency not just the 
  megahertz and following digits.  For example, to go to 147.380 
  plus with software version V1.48 or earlier, you would have 
  entered "C141*140" then "C142*73801".  With V1.64 and 
  following, you enter "142 1473801". 
- Command 151 now lets you turn the radios on and off.  The 
  format is "151 X" where X is 0 to turn the radio off and X is 1 
  to turn it on. 
- Command 152 now lets you recall a memory in the radio.  The 
  format is "152 XX" where XX is the memory to recall. 

Now let 110, the configure autopatch port command, accept only 
one digit if that digit is 0, to disable the patch.  Used to have 
to enter another digit that was ignored to meet the minimum 
length requirement. 

Added command 164 to recall controller and software version.  
Call it automatically on reinitialization. 

Changed reset macro to speak "controller ready" rather than send 
"reset" in CW. 

Changed autopatch hangup message to "call complete at <time>" 

Default port 1 to be a repeater, not a link.  Defaulted ID's on 
for port 1. 

Put the user logon/fail/logoff messages in macros so the user can 
change them.  They are macro numbers 414, 415, and 416, 
respectively.