VERSION 1.17 OF THE ICOM SOFTWARE FIXES A PTT HANG-UP PROBLEM
THE HANG-UP OCCURRED WHEN CHANGING A FREQUENCY WHILE IN TRANSMIT

ALSO INCREASED DATA TRANSFER SPEED WAS ADDED BETWEEN THE CONTROLLER
AND THE RLC-ICM

FOR THE RECORD:
1) COR FROM THE RLC-ICM IS ACTIVE LOW
2) PTT INTO THE RLC-ICM IS ACTIVE LOW
3) AUDIO OUTPUT FROM THE RLC-ICM IS DISCRIMINATOR AUDIO
4) TS-64 TONE UNITS NEED JUMPER JU-7 INSTALLED FOR CORRECT PL DETECTION
5) INITIALIZATION JUMPER IS PLACED BETWEEN R-T PINS
	INITIALIZATION IS THEN PERFORMED UPON POWER-UP
6) NORMAL OPERATION REQUIRES THIS JUMPER OUT OF LINE
7) 2 METERS DEFAULTS TO MODULE 1
8) 220 DEFAULTS TO MODULE 2
9) 440 DEFAULTS TO MODULE 3
10) MODULE 4 IS DISABLED
11) WHEN ENTERING A NEW FREQUENCY, THE MODULE GOES INTO RECEIVE ONLY MODE
12) CONFIGURATION CODE 85 PLACES THE MODULE IN TRANSMIT-RECEIVE ON
13) CONFIGURATION CODE 90 PLACES THE MODULE IN RECEIVE ONLY MODE, NO TX
14) CONFIGURATION CODE 95 PLACES THE MODULE INTO RECEIVE-TRANSMIT OFF MODE

THIS UPDATE WILL NOT CHANGE ANY OF YOUR INTERFACE SETTINGS

LINK COMMUNICATIONS, INC.
TECHNICAL SUPPORT